Installation Manual to replace a 1-Phase Cable of Charge Amps Halo
This article is intended for electricians/installers.
The 1-phase charging cable must have 4 pcs. wires: phase, earth, neutral and the pilot cable.
1. Remove the 6-pin terminal from the circuit board.
2. Then disconnect the old cable from the terminal.
3. Pull the cable out of the grommet and replace with a new cable into the chassis.
4. Connect the new cable to the terminal with the wires as shown below:
| Pilot | Orange |
| PE (earth) | Green-yellow |
| N | Blue |
| L1 | Brown |
5. Connect the terminal to the circuit board.
6. Close Halo.
Please also see the appendix for a more detailed visualization.